The average parked car sits completely unguarded for hours at a time — and most owners never find out until the damage is already done
GuardiLux is an AI parking guardian that installs in as little as 10 minutes — and it's already helping drivers watch over their cars day and night
Picture this: you park in a lot, run into the store for ten minutes, and come back to a fresh dent in the door — no note, no witness, nothing. Or you wake up one morning to find your side mirror hanging by a wire after a completely quiet night in your own driveway.
It happens more often than most drivers realize. A car spends the vast majority of its life parked and unattended — in driveways, office lots, and street spaces — completely unmonitored. GuardiLux exists to change that, and here's exactly how it works.
a few problems you've probably run into
- Someone hit your car — and you have no idea who?
- Come back after a few days parked, only to find the battery drained?
- Hardwire installs too much hassle, too much cost?
- Left parked for days — will monitoring even still be running?
If even a few of these sound familiar, keep reading — this is exactly the problem GuardiLux is designed to solve.
why the cameras and alarms you already have keep letting you down
- Standard dash cams that record 24/7 can drain a car battery dead within days
- Hardwire installs mean cutting into a fuse box, or paying a professional
- Basic loop recording overwrites the one clip you actually needed
- Motion alerts that aren't smart enough — triggered by every leaf and passing shadow
- No way to check in on your car remotely once you've walked away
It's like installing a security camera... that only works while you're home to watch it.
The technology behind 30-day standby protection
Instead of brute-force, always-on recording, GuardiLux is built around a low-power chip capable of AI time-lapse monitoring across three channels using as little as 200mW — while operating reliably across a wide temperature range, from -20°C up to 70°C, the kind of swing a car actually sees parked outdoors.
Night vision runs on an IMX675 STARVIS 2 image sensor, so the low-light footage that matters most — a figure approaching at night, a door handle being tested in the dark — is actually usable. Connectivity is handled over 5.8GHz WiFi with full control from the companion app.
Three systems doing the actual watching
Custom Security Zones, Every Angle Covered
Three-channel AI human detection keeps watch around the vehicle, and custom AI alert zones let you decide exactly which areas should trigger a warning — the driver's-side door, the space behind the bumper, or wherever matters most to you.
AI Spots a Threat, the Strobe Fires First
When someone enters the alert zone and lingers for more than 5 seconds, GuardiLux first starts recording, then fires a strobe warning — flashing three times. Evidence first, deterrence second.
1-Second Collision Wake-Up + Smart Evidence Compression
The moment an impact is detected, GuardiLux wakes and starts recording in about a second, then compresses the two minutes before impact into a 5-second lead-in and combines it with 15 seconds after — one complete evidence clip, automatically.
Two ways to power it — no hardwiring either way
External Battery Mode
Plug-and-play, with no impact on your car's starter battery. As long as you drive normally each day, a single charge keeps GuardiLux running for up to 3 straight days of standby guard.
OBD Power Mode
Draws power through the OBD port for extended standby — enough to keep GuardiLux watching your parked car for up to a full month without needing a separate charge.
Either way, there's no cutting into your car's wiring — it's plug-and-play. Actual install time depends mainly on how many camera channels you're running, covered below.
Meet GuardiLux
- No-hardwire install — about 10 minutes for 2-channel (longer for 3-channel, which runs a rear camera cable)
- Battery-friendly power, plug-and-play
- 3-channel AI human detection
- Custom AI alert zones you define yourself
- Up to 30 days of standby parking guard
- 1-second collision detection wake-up
- Auto strobe warning on proximity detection
- 5s-before + 15s-after auto evidence clip
- Low-power chip — as low as 200mW, -20°C to 70°C
- IMX675 STARVIS 2 night vision · 5.8GHz WiFi & app control
The 2-channel (front + cabin) setup needs no rear camera wiring and installs in about 10 minutes. The 3-channel (front + cabin + rear) setup requires running an extra cable to the rear camera, so installation takes longer.
The everyday moments GuardiLux is designed to catch
A shopping-center fender-bender that would otherwise go unreported — instead caught on camera, with an automatically generated before-and-after clip clear enough to identify the other vehicle.
A figure lingers near the car after midnight — the AI flags it and fires the strobe warning before anything actually happens.
A car left at the airport for weeks on OBD power, still quietly monitored the entire time without needing a charge.
Your car is unguarded more hours than it isn't
Without a device like this
- No evidence after unexplained damage
- No way to check in on the car remotely
- Battery drain trade-offs with always-on cameras
- Ongoing low-grade anxiety about where you park
What GuardiLux changes
- Automatic evidence clips when it actually matters
- A strobe warning that deters trouble before it starts
- Up to 30 days of standby watching
- Simple, no-tools installation, either power mode
Tell us about your real experience
If parking safety is on your mind, or you've been curious about a device like this, we'd love to hear your take. It takes about 2 minutes, and you'll be entered for a chance to win a $15 Starbucks Gift Card.
Take the Survey — Win a $15 Starbucks Gift Card
About 2 minutes: your usage habits, which features matter most, and your channel and power preferences. Complete it for a chance to win a $15 Starbucks Gift Card.